Cutting runners for wheelchair ramps
If you are building a ramp on a 1:12 or 1:8 pitch. What is the best way to figure your top and bottom cut angles?
COMMUNITY FORUM
Recent Posts
over 7 years by sawdusttv
0
answers437
Views
Blueprint program(measured drawings) for pc
I am looking for a user friendly Blueprint(measured drawing) program to use on my PC. I have tried the CAD programs with no seccess, they are to co...
over 7 years by Kate2005
1
answers601
Views
CUTTING HOLE THROUGH EXTERIOR BRICK WALL?
WHAT IS THE BEST WAY TO CUT A HOLE THROUGH AN EXTERIOR BRICK WALL IN ORDER TO RUN PLUMBING AND ELECTIC LINES THROUGH IT FOR A NEW LAUNDRY ROOM ADDI...
over 9 years by homebild
1
answers876
Views
CUTTING HOLE THROUGH BRICK WALL?
I NEED TO RUN PLUMBING AND ELECTIC, UP FROM BASEMENT UNDER KITCHEN COUNTER AND OUT THROUGH EXTERIOR BRICK WALL, TO A SCREEN PORCH WITH CONCRETE FLO...
over 9 years by plumber Tom
1
answers225
Views
septic smell
How long has it been since the septic tank was pumped out? It may be full, this will cause sewage to back up septic lineand cause an smell. You mig...
over 9 years by sawdusttv
10
answers41
Views
? reading a tape measure
thanks to all who replied.
over 10 years by sawdusttv
4
answers870
Views
? reading a tape measure
there is a little black diamond shape every 19 1/4" on a tape measure. can anyone inlighten me to what this is used for?
over 10 years by sawdusttv
4
answers268
Views
cutting sharp miters in wide lumber
I HAVE BEEN IN CARPENTRY FOR 20 ODD YRS. I HAVE NOT FOUND A EASY AND ACCURATE WAY TO MAKE MITER CUTS SHARPER THAN 45 DEGREE ANGLE IN WIDE LUMBER. (...
over 10 years by doug seibert
2
answers114
Views
