THANKS for the fyi, DanO!!! Is there a best way to flush out the "crud"? or should i NOT put water in that air dome? Thank you thank you than...
FIXED! :) The tube you refer to WAS attached at both ends (that's what I was hoping was the problem). However, the pressure switch, if I am using ...
it's fixed! i cleaned some horrific "GUNK" out of the pressure switch "cap" on the side of it...tried to start the washer again and lo and behold, ...
ok the pressure switch sounds more likely. i was simply using fill valve because that's the term i was being given by everyone. had no luck finding...
unfortunately...the fill valve tubing is firmly in place on both ends... i'm at a loss here... what's next? Thanks! Thanks! Christensens
Removed front and top panel plus control panel. Fill valve tube is attached firmly at both ends. all wires and tubing seem to be where they belong....
i'm DIY-challenged on washers :). what's the easiest place to start opening up the front? I'm HOPINGHOPING it's just that the off-balance part dis...
Good (not really) morning. Started a wash load last night at bedtime and had to stop it during the first spin because it was off balance (klunk klu...