Tieger plumbing
When in doubt hire a licensed , insured plumber before you do some real damage
Started doing new constuction again,. 50 family homes for middle income
Sewer and drain cleaning equpment
When in doubt hire a licensed , insured plumber before you do some real damage
2
answers545
ViewsPerfect time to have a pressure /temperature balanced shower body installed to protect children from being scalded
1
answers157
ViewsWe sometimes use "Key grease" found in plumbing supply stores and it is used on the spindles and works for both hot and cold water supplies.. good...
1
answers623
ViewsYour very welcome
5
answers692
ViewsTry hydrogen peroxide as it may kill the bacteria causing the odor
2
answers818
ViewsI totally agree a trap is the best way to go and I would use a running type of trap with Two clean outs and a fresh air inlet installed and the V...
4
answers209
ViewsA porcelain steel tub is the cheapest on the market for a very good reason. We normally replace it with either Americast Or cast iron
1
answers660
ViewsWhy not stick with the neighbor who knows plumbing quite well and let him keep trying things out? You might hurt his feelings thus let him keep ...
1
answers898
ViewsRent a snake with a 3/4 wire open the street side of your building house trap then open the house side and hope it is only a trap stoppage.. IF ...
1
answers533
ViewsThe thermocouple just maintains pilot light If the pilot light does not stay on then it need replacemsnt BUT a 7 year old heater I personally wo...
5
answers708
ViewsAnyone check the wax gasket to make sure there is a decent seal?
1
answers848
ViewsWhen were the burners last cleaned? did any check for spilage (down drafts)?
5
answers232
ViewsHow do you know you need an expansion tank>?
2
answers351
ViewsHas anyone suggested a Swiss cap as it will let the exhaust out but will not let any rain in?
1
answers300
ViewsWater is stupid it does not care to know what makes it hot Also mixing metals (ferrous and non ferrous) the metals do NOT care to know if it is...
3
answers21
ViewsCheck for a loose washer either on the fill valve or the shut off valve controlling water to the tank
1
answers28
ViewsLots and lots ans lots of insulation
2
answers603
ViewsI use cast Iron piping and depending on the GPM flow rate would determine the fixture (normally 1 GPM = 1 FU) In no case would I use less then ...
1
answers538
ViewsHard to tell unless you actually remove the bolts disconnect the water supply AFTER shutting it off and physically checking
1
answers288
ViewsOnce someone uses chemicals they mask what the problem is. Also when I know someone used chemicals prior to our working on the drain there is a ...
1
answers325
Views