Have someone check your vent terminal as you may have a combination system where storm and sanitary go into the same system and if your vent ter...
SylvanMember since 01/24/06
What project are you working on now?
Started doing new construction again,. 50 family homes for middle income. Started a new company fire suppression piping
What is your favorite tool?
Sewer and drain cleaning equpment
What's your favorite Bob Vila memory?
Seeing Bob in Connecticut in Sears.
I would check the piping connections going into and from the heater as someone may not have installed a dielectric fitting to prevent electrolytic ...
The coefficient of expansion per degree per inch causes piping to expand and contract unless proper provisions are made during the installation the...
I installed several of these in areas where the dangerous possibility of ACID being splashed on someone is present. Check Bradley or any manual...
Actually it is called a Douglas valve and the TUBE is called the over flow tube and the water line leading to the over flow tube attached to the Do...
Yes, Most plumbers know how to install a "vent" We can install a dryer vent Gas or electric and drainage venting based on fixture unites and we...
Nope it is NOT normal. Personally I would shut the power and call a professional before you burn the place down
1- When I had a journeyman's card it stated I was to work under the direct EMPLOY of a licensed master plumber NO SIDE WORK. all work was to be ...
Get yourself some Hercules "LEAD FREE Solder in paste form" normally 95 -5 even though the directions say not necessary to clean the tubing an...
No you do NOT have to use CPVC, you can use Brass piping schedule 40 or copper tubing type L
I'm not sure what you mean. NYC code for example requires 1- 4 " main vent stack to penetrate the roof and we can connect all the fixture vents...
1- If you have a tankless coil and it has a pin hole that would account for the elevated pressure 2- If the automatic feeder set 12-15 PSI is d...
The stand pipe should be at least 2" diameter and normally 18" - 30" high and trapped and vented
You have to find the frost line in your area and if that is a problem you can always use sewerage ejector to pump the waste up hill. The piping...