Something is over loading the circuit IT TRIPS as a safety device call a licensed plumber or licensed electrician who knows how to replace the heat...
SylvanMember since 01/24/06
What project are you working on now?
Started doing new constuction again,. 50 family homes for middle income
What is your favorite tool?
Sewer and drain cleaning equpment
Try throttling down on the valve on the left hand side below the tank. Could be a lose washer /diaphram
Want to know about TOXIC PVC http://www.ejnet.org/plastics/pvc/ http://archive.greenpeace.org/toxics/reports/whatswrong.pdf http://www....
Al you need to buy heat tape and INSULATE that area. The tub wont drain because the trap froze and hopefully it did not split BUT I wouldn't bet...
If the pipes cannot be thawed by leaving the heat on you may have to use a hair drier CAREFULLY and start at the top of the pipe near the open fa...
There is shut off valve on the left side of the tank throttle it closed slightly and this should stop the noise
The reason the other poster was able to get her water flowing and you cant is simple.. SHE gave a great smile and you didnt (teasing) Just...
Your very welcome with a smile like that I would have drove to PA and I hope your husband enjoys his mixed shower
Get a water Jetter and use warm water it will blast the right through the ice. I Hate PVC as I normally would use hot water with the Jetter but th...
First off WHAT A GREAT SMILE the BEST I have ever seen on any list Second leave the C/W faucet open when your home and turn up the heat hopeful...
It is going to take some time for the dripping to stop as drywall and or plaster hold water like a sponge and will depending on the ambient humidit...
Could be a wasker /debris blocking the opening OR as some handles like American Standard are plastic and the spline just slips and not actually tur...
I was a firm believer of cast Iron bath tubs until I installed my first acrylic tub in 1981 and never installed another cast iron tub since. Cas...
Who sized the expansion tank to make sure is is the appropriate size? What is the set pressure recommended?
Are you taking about the built in divertor part of the shower body or the type that is part of the tub spout?
Normally the trap is brass or chrome plated brass and not ferrous metals thus trying to remove a ferrous nipple (galvanized) from the trap I find i...
Better call a lawyer BEFORE you get hit by a car or lightning after all today there are lawyers able to sue about anything. I am sure some law...
You could also cut the pipe 2" or 3" away from the hub and use a MISSION cap this way you have another cleanout OR buy a No Hub coupling NOT Fernco...