mmmmmmmmmmmm
Hot water in a toilet MMMMMMMM GREAT for cleaning I guess Plungers well they are good on possibly soft stoppages. For bottles, combs, Q -T...
COMMUNITY FORUM
What project are you working on now?
Started doing new constuction again,. 50 family homes for middle income
What is your favorite tool?
Sewer and drain cleaning equpment
Recent Posts
about 7 years by Sylvan
3
answers94
Views
No way
Sorry but nothing lasts forever and I have a junk yard full of plastic piping failures. The reason plastic is used by some folks ( I only use ...
about 7 years by Sylvan
1
answers175
Views
Your in luck
A bath tub waste is 11/2" normally and a shower is 2" so the waste is not a problem BUT the location of the trap is and thus walls have to be take...
about 7 years by Sylvan
1
answers707
Views
Welcome to the
Welcome to the wonderful world of plastic the noisy piping systems and improper venting Even Charlotte piping corporation the manufacturer of...
about 7 years by Sylvan
5
answers175
Views
SUE all involved
I hope you got your money back from the franchise wonders. Many times a kitchen sink blockage should NOT BE SNAKED but water jetted to remo...
about 7 years by Sylvan
6
answers773
Views
Tieger Plumbing
No problem in NYC I ran water lines in sky scrappers much higher then 400 ft and that was vertical. In the ancient Roman and Greek times folks ...
about 7 years by Sylvan
5
answers356
Views
Tieger Plumbing
You have two choices both involve shutting off the main water supply 1- Shut off the water supply disassemble the valve for the toilet and try t...
about 7 years by Sylvan
1
answers308
Views
GOOD LUCK
One your up coming retirement, If I had stayed in when I joined the Navy when I was 17 I would have had 41 years in go figure how time flys
about 7 years by Sylvan
5
answers614
Views
Hi Jim
Q Tips are notorious for this kind of blockage that can drive people nuts as water passes but paper gets caught. Have a great holiday
about 7 years by Sylvan
5
answers82
Views
no problem
For the BEST I would use T.P copper (thread less copper) Silver brazed with Flagg flow fittings. For the drainage line I would not accept anythi...
about 7 years by Sylvan
3
answers272
Views
Moans as it has passion?
The ballcock needs to be checked or the globe valve should be throttled down slightly. Many toilet moan because people take them for granted an...
about 7 years by Sylvan
1
answers684
Views
RE cast Iron hub
Normally unground piping is a min of 2" for waste and the lead in the hub I usually burn out carefully and then caulk in the new piping as needed....
about 7 years by Sylvan
3
answers881
Views
Aerator
Did you bother to remove the new Aerator prior to turning on the water? If not then it is most likely filled with mineral deposits blocking the f...
about 7 years by Sylvan
1
answers930
Views
Adjusting
means that closing the water supply slightly so less volume is flowing through the piping and excessive velocity can cause all kinds of wacky sounds
about 7 years by Sylvan
3
answers972
Views
Oh my
Some inferior codes do allow for the use of a 11/2" kitchen waste line as these codes normally serve bottom of the line housing and areas where ...
about 7 years by Sylvan
3
answers213
Views
Sylvan Tieger
1- Mixing valve failed 2- Stratification of the hot into the cold water lines as heat goes to the absence of heat (HVAC STUFF) 3- Cross c...
about 7 years by Sylvan
1
answers973
Views
Sylvan Tieger
Sorry but if you have to ask your better off hiring a LMP and watching. Shower body's can be installed via copper tubing sweating or by IPS with...
about 7 years by Sylvan
1
answers639
Views
Nope Bill impossible
When plumbing contractors install copper or brass piping in new construction or alterations we cover said piping with cold tar or flashing cement ...
about 7 years by Sylvan
3
answers383
Views
Asking how much?
Suppose I told you I have a Car and I cant seem to get to to start running how much will it cost and I live in NYC? 1- Did I run out of gas? ...
about 7 years by Sylvan
3
answers367
Views
