door hardware cleanup
The best way to clean these parts is to remove them from the door and soak them in paint remover. Clean off all the paint then use a brass polish ...
The best way to clean these parts is to remove them from the door and soak them in paint remover. Clean off all the paint then use a brass polish ...
2
answers492
ViewsAs stated above, the contract called for ridge vent, and you can enforce the contract. Installation will require only removing the hip-ridge shing...
6
answers959
ViewsTo Harold's sage advice, I would add that if the furnace is centrally located below the first floor, these rooms are the ****hest distance from the...
7
answers82
ViewsReally good question here. Plants do use light in the blue and red portion of the visible light spectrum and reflect the green light in the middle...
1
answers500
ViewsHigh gloss gold paint is going to show every defect in the ceiling and, like any metalic, will be very difficult to get an even looking appearance....
2
answers185
ViewsI agree with 5slb6 that Shieldz would be a good primer / sizing. In your case since integrity of the plaster is in question you should consider Zi...
2
answers483
ViewsTo repair the wall you should skim-coat any deep gouges, dents and other defects with an all purpose joint compound and sand smooth. The damaged w...
1
answers712
ViewsThe material sounds like mastic, and it may be the adhesive from a previously removed tile installation that has been covered by carpet. To find o...
1
answers617
ViewsFirst a small correction to your link: http://www.uncoolcentral.com/images/dump/stupid_pipe.gif Second a question: What is the rusty flange con...
3
answers155
ViewsContinue construction through the entire framing phase, including roof, windows and exterior barrier wrap, sheathing and siding. At this point you...
1
answers764
ViewsProfessional termite control is expensive because it is labor intensive and the chemicals are costly. The companies also generally provide warrant...
1
answers529
ViewsGood job pointing dadof5 to the solution of his problems. Obviously his exterior wall was all silted in sealing water in the basement and preventi...
29
answers638
ViewsTypically expect to apply one coat of primer and two coats of color finish. You can have primer pre-tinted, and this will often allow once coat of...
1
answers346
ViewsI would forego the tape and use spray adhesive like super 77. You will get a great bond, neater job and very easy to do. Be sure to ventilate.
3
answers428
ViewsThose gaps you uncovered were intentionally built into the wall to allow water to drain out of the wall to the drain. They must have been plugged ...
29
answers128
ViewsThis furnace may be subject to a recall due to a defect that causes failure of the heat exchanger. I copied information and model numbers below fr...
1
answers1009
ViewsAlmost any glazier can easily fabricate aluminum framed panes to replace your missing storm panes. Look in the yellow pages under glass. The fram...
1
answers890
ViewsThe problem is easily solved by applying a reflective window tint to the glass on the storm door. Window tint film is easily applied and will refl...
2
answers721
ViewsAsbestos floor tile presents a fairly low risk, even during removal if excessive breaking and any abrasive removal is avoided. The floor tile cove...
1
answers374
ViewsYou basically have nothing to lose by pickle staining the wood. I recommend you look up a pre-mixed pickle stain rather than white wash, but the e...
1
answers575
Views