wallpaper and sizing
Sizing is part of the wall preparation to provide a non-pourous surface that adheres well, but can be stripped. It is painted (rolled) on the wall...
Sizing is part of the wall preparation to provide a non-pourous surface that adheres well, but can be stripped. It is painted (rolled) on the wall...
1
answers706
ViewsI did this to a built-in entertainment center so I could roll in a larger TV. Mark your cut line and use a high quality saber saw. I used a Bosch....
4
answers479
ViewsAs long as the stove fits the cutout it should be no problem. If you can draw a picture of the outlet configuration, the stove dealer can match yo...
4
answers963
ViewsIt helps to get feedback to see what solutions work for a problem. Let us know how the new anode works out for you.
8
answers514
ViewsI agree with your painter and would strongly favor a satin finish over semi-gloss. The reflectance of semi-gloss would make the house "glare" in t...
1
answers782
ViewsThis is a question of economics and finish. There should be no performance difference between any of the choices since you are painting. Clear ce...
2
answers110
ViewsUsually a rusted ferrule or joint in a galvanized gutter can be simply painted with a good primer, then top-coated with finish paint. Remove as mu...
2
answers220
ViewsYou need to use drywall screws to tighten down the drywall next to the popped nails. Pull the nail if possible, or drive it flush, then repair wit...
1
answers776
ViewsManufacturers limit paint warranty to replacement of product only. No way are you going to find it worthwhile to pursue a claim for painting labor...
7
answers236
ViewsThe amount of glue removal necessary may be less if you are installing a floating floor with cushion. I also have used scrapers, solvents and sand...
3
answers582
ViewsJust a wild guess, but if your new hot water heater has a magnesium anode, that can be the cause of hydrogen sulfide smells. An aluminum anode doe...
8
answers485
ViewsMaybe one of these would work. Not quite the diameter, but its the right height: http://www.tablelegs.com/kitchentablelegs.htm
2
answers611
ViewsLet me clarify. The "workmen" (framing carpenters, are not at fault if they were following the design drawings and locating walls properly. The p...
18
answers177
Views4x4 will be strong enough for anything shy of a hurricane, but you will need 10' - 12' long posts anchored in concrete.
2
answers374
ViewsNow I understand! You are being a little too precise. Given the length of each run, there are at least 12 full shingles being laid on each row. ...
5
answers214
ViewsThe first place to start is to recalculate your square footage. 8 square feet is only a 2'x4' area. This would not fit a bathtub. If you meant 8...
1
answers514
ViewsA single story detached garage is subject to building permits in most California counties and incorporated cities. Where I live, the foundation mu...
2
answers765
ViewsThe builders use a plan drafted by an architect to frame and finish the structure. GemCraft hires architects and probably tells them we want as mu...
18
answers970
ViewsI think you are talking about the reveal for the shingle tabs from one row to the next. This can range from 5-1/4 inches to 6-inches depending on ...
5
answers232
ViewsIt may be impractical to keep or repair plaster that has widespread structural damage due to moving a house. Plaster repair is probably a contract...
1
answers389
Views