Asbestos results
Asbestos was identified in many materials. A few questions... Who did the inspection? Are the results based on laboratory analysis using polarize...
Asbestos was identified in many materials. A few questions... Who did the inspection? Are the results based on laboratory analysis using polarize...
13
answers482
ViewsI have marked the objectionable posts to be deleted. You can buy soaking or whirlpool tubs of almost any size. A tub can also be made using ply...
1
answers72
ViewsIt sounds like the lateral from your house to the sewer main is collapsed. This requires excavation and replacement, and can require repair to sid...
2
answers570
ViewsNumerous products can off-gas following a kitchen renovation. Adhesives, plywood and particleboard (cabinets), and finishes all potentially emit l...
1
answers61
ViewsThe State of Colorado does not include residential structures with fewer than 4 units in their definition of a "facility". That means the State doe...
13
answers902
ViewsI would treat this the same as any subfloor. Its sole advantage is that it is made with waterproof glues and coatings. The use of a 1/2 or 5/8 pl...
4
answers818
ViewsDude, I don't care if your house wears pajamas. What makes you think siding should match? I have seen a number of artistic shantys that, aestheti...
1
answers973
ViewsThis is a 4 x 8 sheet product. What is the application? Is this an exterior deck or enclosed house deck. I assume, the decking was simply instal...
4
answers590
ViewsYour location is also important to determine applicable regulations. I many parts of the country, single family homes are not regulated for demoli...
13
answers386
ViewsYou are describing "Veneer Plaster" which is a plaster skim coat. A couple brands I know of are Kal-Kote http://www.gypsumtoday.com/library/produ...
1
answers949
ViewsWith all due respect to the lady at Lowes, the earlier advice to skim coat by 5slb6 was correct. The primer is usually a thick paint. It builds u...
3
answers287
ViewsFor insulation purposes the easiest short-term solution is to blow in cellulose insulation. Your house is not so air-tight that moisture should be...
2
answers846
ViewsThis was a very well written, and fair analysis of the process. You should copy it to the company. From a formulation point of view, it should no...
5
answers343
ViewsYou can, but it will look like crap. The outlets and coverplates will end up with a flat finish very easily damaged (chipping and dirt). You shou...
6
answers835
ViewsDoes insulation of this age have asbestos in it? That would be VERY unusual. This is most likely fiberglass, and could be mineral wool. The ...
6
answers348
Views"Is it possible this insulation can get into the air ducts?" Not likely, most forced air systems are under positive pressure on the distribution...
6
answers653
ViewsThe rating normally applies per bulb or socket. The wiring and insulation could be damaged if light bulbs (individually) exceeding 100 watts are u...
1
answers987
ViewsUnfortunately there are no good shortcuts for windows with blown seals. The glazing needs to be replaced (not the whole window). But if that many...
9
answers128
ViewsYou cannot harm a floor coated in polyurethane by walking barefoot.
1
answers153
ViewsI use Minwax gel stain for wood, fiberglass and metal along with a graining tool or dry brush technique. Just work with the stain until it looks r...
4
answers385
Views