 |
Finishing Slab wall...?
Posted by John 2000 on September 29th, 1999 03:42 PM
In reply to Finishing Concrete Slab Wall by Bill on September 29th, 1999 12:02 PM [Go to top of thread]
Bill,
First clear the area of all rubbish,Hire an air compresser
and a airhammer (wind hammer) with a flat chisel end with
teeth on it, take the surface off the wall by a 1/4",
Have two plasterers render the wall with cement made up
of sharpe sand and cement 1 of cement and 3 of sand.
not too thick, let it dry ( about a week) then render the
wall again for the finishing coat.
If you only put one coat on the wall, after a time
you will see where the joints in the concrete are, and you
dont want that ( it looks cheap).
Try that and see what happens.
John 2000.
Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
