Thanks for the bum advise, TL

Posted by OP on August 2nd, 2003 09:59 AM
In reply to Angle figuring by TL on July 17th, 2003 11:11 AM [Go to top of thread]

Post Reply |

Watch this Post

Moderator Post:
> Cutting Crown Molding by Handyman on 05/19/2005

I did as you said. My room angles are 90 degrees. So I subtracted 90, divided by 2 and ended up cutting my crown moulding straight across. And you said it was so easy and no angle guessing!

Was this post helpful? Yes: or No:

Post Reply

Topic History:

Crown Molding Miter Cuts by Kurt A. Blevins 1/5/98 11:57 AM (: 1, : 1)
Cutting Crown Moldings - Compound Mitre Cuts by Dan Rudman 1/5/98 03:08 PM (: 1, : 5)
compound mitre cut by ROGER 3/13/99 02:56 PM
compound mitre cuts by Frank Vandecruys 8/3/00 04:50 PM (: 1, : 1)
excel sheet for crown moldings by Ronald Woodruff 10/1/02 06:27 PM
miter cuts for crown molding by farah h. lowe-bey 10/15/02 02:42 PM
Crown Molding by Norma 1/11/03 05:13 PM (: 1, : 0)
cutting crown mold for ceilings inside and outside corners by mitchell conner 1/30/03 11:52 AM (: 1, : 0)
cutting outside corners for crown molding by jeff 2/26/03 09:26 PM
crown moldings spreadsheet by Richard 3/16/03 12:19 PM
crown moldings/spreadsheet by MIKE LAFLAM 4/12/03 08:29 PM
crown molding spreadsheet by jay strakal 4/13/03 10:50 AM
Crown mold by Al Threlkeld 4/29/03 04:14 AM
Awesome way to cut Crown Molding by CK 5/14/03 10:39 AM
crown mold by kc 6/28/03 03:00 AM
Angle figuring by TL 7/17/03 11:11 AM

Topic Follow-ups:

You are mistaken by TL 8/11/03 03:26 PM
Excel spreed sheet by Grayfoxx 5/14/04 10:39 AM

BobVila.com

Thanks for the bum advise, TL