 |
rockwell 34-335
Posted by Scott Sansbury on August 18th, 2003 07:09 AM
In reply to Rockwell table saw by Ken Hunerdosse on July 26th, 2003 07:21 AM [Go to top of thread]
1 of 1 people found this post helpful
are you sure that the bearings are bad?...I have the same saw, and I thought that the bearings were going out- it started making a horrible wobbling noise.... I called my local Delta/porter cable repair center, and the guy new exactly what the problem was--- the belt needed replacing...He said that the bearings rarely go out on these saws, and when the belt gets worn, it sounds like bearings going out.... My blade does have a little wobble at startup and shutdown, but when it is up to speed, it cuts true.I have a friend who is an experienced cabinet maker, and he said that the"blade wobble" was a tendency of this saw. I keep looking for an excuse to buy a new tablesaw, but I just can't kill this one. The fence is accurate and it cuts straight. I hpoe that this helps. Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
