BobVila.com

Home

cutting crown molding

Posted by RC on September 11th, 2003 11:12 AM
In reply to 45/45 mitre and bevel angles by brenshaw on June 8th, 2003 10:58 AM [Go to top of thread]

Post Reply |

Watch this Post

Moderator Post:
> Cutting Crown Molding by Handyman on 05/19/2005

I am using crown molding (beveled)in a room where I have a 90 degree wall. I set my saw's bevel angle to 33.85 degrees and the table angle to 31.62 degrees.

Question?

If I am using crown molding (beveled)in a room where I have a 45 degree wall. What is my bevel angle and table angle?

Was this post helpful? Yes: or No:

Post Reply

Topic History:

Crown Molding Miter Cuts by Kurt A. Blevins 1/5/98 11:57 AM (: 1, : 1)
Cutting Crown Moldings - Compound Mitre Cuts by Dan Rudman 1/5/98 03:08 PM (: 1, : 5)
mitre cuts by McArthur McKinnon 4/16/98 07:36 PM
compound mitre cuts by bob caceci 11/26/99 10:46 AM (: 2, : 0)
horizontal crown molding ,inside and outside corners. by allen gabriel 9/29/02 12:39 AM
45/45 mitre and bevel angles by brenshaw 6/8/03 10:58 AM

Topic Follow-ups:

cutting crown moldings by james wright 1/2/04 04:29 PM