 |
think and do
Posted by dp on January 30th, 2004 02:05 PM
In reply to Moulding by Fed Up With Sears on January 30th, 2004 12:34 PM [Go to top of thread]
do a little thinking
do some measureing
cut carefully
place where you want it with one or two nails
when your sure everything is correct, put the rest of the nails in
chaulk the edge with paiters chaulk, fill nail holes with wood filer, wipe with wet towel before it dries so you dont have to sand
prime and paint
sometimes i like to buy pre-primed molding as it saves a step, or prime it before installation as you donjt have to worry about cutting in along floors and what not, saves some time, you could also paint it before installation, then just touch up after nailing it up
remember measure twice, cut once
dp Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
