Just had that happen to me last night!
Posted by Winston Gregory on February 10th, 2000 04:09 PM
In reply to Garage door not going down by Brett Johnson on April 24th, 1999 09:02 PM [Go to top of thread]
5 of 6 people found this post helpful
There should be three wiring screws. A red, white, & black. The red and white connect to your wall opener. However,
the black and white connection goes to the outside coded
opener. I don't have the outdoor opener so you wire around it. 1. Take a piece of wiring, like that used to wire the wall
unit, and strip a section on both ends of the wire. 2. wrap BOTH white ends on the white screw, and BOTH the black
or striped whatever kind of wire you are using to the black
screw. It is some sort of wacked out safety. That will fake the system
out and the door should operate correctly.
Was this post helpful? Yes: or No:
|
Post Reply
Watch this Post
