garage door opener remote instructions

3 of 3 people found this post helpful

Post Reply | Watch this Post

Moderator Post (s) for this thread: > GDO manual by Billhart on 12/29/2006 > Garage Door Opener by Billhart on 03/09/2007 > Garage Door Opener by Billhart on 08/27/2007 > Garage Door Opener by Billhart on 09/26/2007

Hi Dee, I had the same thing happen and bought the page dealing with the remote from Sears. They charged me $13 for one page that cost them a stamp to mail! I was SO MAD! My model no. is 139.53859, but maybe it will work for you. To erase old programming, press and hold the SRT button until the light turns off. To program it, you press and hold the remote button (if there are 3, just press the big one), then press and release the green SRT button on the right side of the back of the opener (not remote). The opener light will flash once to show that the remote and opener are in sync. Repeat for additional remotes. It says on the sheet that these instructions are also on the opener itself, so you can check there if this doesn't work. Good luck!