Home > Ask a Question > Fix It Forum > Neptune FL circuit board,front seal,drum support,bearings...
Login | Register

Neptune FL circuit board,front seal,drum support,bearings...


Posted by Doug Bourhenne on September 11th, 2004 11:28 PM
In reply to maytag neptune by Unregistered-elaine on September 9th, 2004 01:21 PM [Go to top of thread]

2 of 2 people found this post helpful


Moderator Post:
> Maytag Answer to Most Posts - Class Action Settlement by Handyman on 11/29/2004

The first (ciruit board) and second (rubber seal AKA mold) repairs were covered under warranty. But the broken inside drum arm was a free part but not the labor $119.00 and now the Main drum bearings are failing (super loud) The repair tech said it was from using the wrong soap non HE, it's not stated as mandatory in the manual. Imagine using laundry soap in a washer! And its everyones fault the water gets trapped and causes mold too. So folks don't use soap and water in your mashine and you wont get these problems and as far as the bearings and ciruit broads burning up I suggest not turnning on the machine and it wont break!

Was this post helpful? Yes: or No:


Topic History:

Topic Follow-ups:







About  | Press Room  | FAQ  | Contact  | Sitemap  | Privacy Policy  | Terms of Use  | Help

© 2009 BobVila.com