 |
I'm having exactly the same problem
Posted by mooseit on October 11th, 2004 11:58 PM
In reply to Lid Switch? by DanO on September 20th, 2004 02:03 PM [Go to top of thread]
1 of 1 people found this post helpful
My model # is 110.22722100 (110 is preprinted, 100 is smaller than the 22722). DSW says last load drained but did not spin. In testing empty it fills fine, agitates to end of normal cycle fails to drain. If I move it ahead to rinse, it agitates again to end of cycle and fails to drain. Moving it to spin it also fails to spin. Will lid switch affect both of these (draining and spinning)> Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
