 |
Wiring
Posted by Jasper on February 3rd, 2005 02:05 AM
In reply to Wiring a light switch with a pilot light. by Unregistered-Pat on February 2nd, 2005 11:17 AM [Go to top of thread]
* Use a single pole double throw (spdt), or three way switch, on both ends. Run an additional wire for the indicator light. On switch 1, run 110 volts to the center terminal. run a wire from the N/C terminal to switch 2 N/C terminal. Same for the N/O terminals. On switch 2 run a wire from the common terminal to the light you are lighting and another wire from the same terminal back to switch 1 indicator light. Any time the light is lit, the wire going back to switch 1 lights the indicator. Check your wiring...
Adios... Jasper Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
