Moderator Post (s) for this thread: >Fixed :)byDanO on 03/05/2005
** we need to replace the igniter... the wires go into a hole in the back of the oven. how do i get to the other end of the wires to change it? it is a ge model # jgbs04pew2ad. **
In order to get to the factory connector for the ignitor wiring, the range may need to be pulled out and serviced from the rear.
To save time, most technicians will usually just cut the ignitor wires and splice them together using *ceramic/porcelain* (NOT plastic) wire nuts as described at the link below about the ignitor used on that model GE range:
on 
Post Reply
Watch this Post
