 |
Stud size and spacing
Posted by EdF on July 17th, 2000 08:11 AM
In reply to stud size follow up by Brian K. on July 15th, 2000 08:23 PM [Go to top of thread]
Let me get this straight.
-- You're going to save 30 cents per stud using 2.5"
-- You're going to spend time and $$, putting wire behind your studs to hold the insulation in place. I'm in the middle of the same project. I found the difference in cost to be less (in the neighborhood of 20 cents), but this only adds up to about $10 extra for a 20' x 20' room. If you're concerned about the insulation touching your foundation wall, why not use the poly-wrapped insulation? Besides, fiberglass doesn't 'wick' water like cotton, so why worry about a gap between the walls?
Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
