 |
Bruising the mortar,?
Posted by John 2000 on August 9th, 2000 05:05 AM
In reply to Mixing mortar in a cement mixer by Joe on August 9th, 2000 12:48 AM [Go to top of thread]
Joe. Hi.
all you have to do is 3 of sand. i of cement and
water, the trick is the water, count how much water
you use on each mix, if its to dry, then add a little
water, if its too wet then less.
If you use a sharp sand ( gritty) then I use 4 sand
or if its a clay type sand then 3.
but I'm not a bricky, so try it first ( and see if
its ok for you,)
John 2000.
Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
