this question is in regards to a Kenmore 90 series washer mod# 110.26902692. after cleaning the cold water sediment screen per a suggestion from this forum(thanks), the washer seemed to be working great, yesterday. however, today it stopped agitating & began clicking in the middle of the wash cycle. it was the 1st time we used it after moving the unit & cleaning the filter & moving it back & leveling it. I forwarded the cycle to drain, then rinse etc. to no avail. i'm assuming a clutch problem or loose bolt somewhere. what should i be looking for before i begin to take her apart.
thanks again
ray
Post Reply
Watch this Post
