 |
unadjusted service
Posted by HKestenholz  on December 2nd, 2008 04:58 PM
In reply to answer:lennox G24M3/4-100A-2 by hg863863 on December 2nd, 2008 04:25 PM [Go to top of thread]
 | 
Moderator Post (s) for this thread:
> I need a clue by HKestenholz on 12/02/2008 |
People can play with pressures; but unless they have the instruments to know what the resulting pressure is, there is no safety.
"Do-It-Yourselfers do not have the tools, nor training to use them; so when a new part is put into a machine, there is no guarantee the new part will solve the problem. Thus the device that had a new part installed without adjustment with the right instruments probably won't work right, so is labeled a 'lemon' and a new heating or cooling machine is purchased to replace it. Hopefully, the new machine adjusted at the factory will work satisfactorily until an adjustment of a part or a new part is needed. But that is a hope, as the installation and operation instructions that come in the box require the installer to adjust the new machine to the circumstances before leaving the first time it is used."
http://www.heatpro.us/service/dissatis.htm
www.heatpro.us energy businessmen's knowledge
Yes, you really have to find out the MAKE and MODEL to get good answers. There IS more than one machine made. Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
