 |
be sure the piece is WELL supported,,,
Posted by itsreallyconcrete  on January 5th, 2009 09:11 AM
In reply to cutting a undermount stainless steel sink into granted marble by Unregistered-hodge t on January 4th, 2009 08:28 AM [Go to top of thread]
make your cutout using ONLY straight lines,,, this'll require chord cuts on the corners,,, after you get the waste out, you can then use the blade to curve as nec.
we use 4" grinders w/.110/.250 blades,,, method works on granite OR marble but uncertain what 'granted marble' is be definition.
Yes Its Concrete
decorative conc artisans
stain-emboss-sculpt-engrave
concrete repairs
Was this post helpful? Yes: or No:
|
 |
Post Reply
Watch this Post
