nailing crown molding

Posted by Robert Goldthwaite on September 26th, 2001 10:56 PM
In reply to nailing crown molding by Robert Goldthwaite on September 26th, 2001 10:48 PM [Go to top of thread]

Post Reply |

Watch this Post

Moderator Post:
> Mitre Cuts and Crown Molding by Handyman on 05/19/2005

rip a 2x2 with your saw blade on 45 degrees.
with 2 triangular nailers, lag these into the corner (ceiling & wall).
Nail your molding to the nailers wherever you need
set finish nails and fill.

Was this post helpful? Yes: or No:

Post Reply

Topic History:

Crown Molding by Margaret Minto 9/7/97 01:33 PM (: 9, : 3)
Crown Molding Response by Terry Alexander 9/8/97 10:35 AM (: 1, : 5)
Crown Molding by Margaret Minto 9/8/97 07:04 PM (: 1, : 1)
Crown Molding - You by Terry Alexander 9/9/97 03:27 PM
Crown Molding - You're close! by Terry Alexander 9/9/97 03:32 PM (: 1, : 1)
how to cut cove moulding by seumas maccombie 9/9/97 06:23 PM (: 2, : 9)
Crown Molding Thanks by Margaret Minto 9/10/97 03:38 PM
crown molding by Anne 10/12/97 02:25 PM
Crown molding by Hal Jorgensen 10/24/97 12:42 PM
CROWN MOLDING by TONY ALLEN 12/2/97 01:58 PM
crown molding book by John Shutz 1/4/98 10:21 PM
Crown Molding/Coping by Laurie Judd 1/7/98 10:05 PM (: 2, : 1)
After Coping the 45 degree cut on crown molding by Jim Jenkins 2/16/98 10:37 PM
Joining Corners by Jeff 11/20/98 09:51 PM
crown molding help by Sam Jones 1/9/99 05:04 AM
nailing crown molding by Robert Goldthwaite 9/26/01 10:48 PM

BobVila.com

nailing crown molding