View ChannelsFeatured: Workshop
View ShowroomsFeatured: DR® Power Equipment - DR® FIELD and B...

BobVila.com

Home

Sensor and board

Posted by Harold hydronicnetwork.net on October 7th, 2002 10:57 AM
In reply to Payne Furnace Problem by John Wessels on October 7th, 2002 08:54 AM [Go to top of thread]

Post Reply |

Watch this Post

When there is a problem in the ignition sequence, many boards reset by having the power turned off for 30 seconds, then on again. This could be as simple as a bad ground, dirty or mislocated sensor, or as bad as an incorrect draft, or needing a new circuit board.

Was this post helpful? Yes: or No:

Post Reply

Topic History:

Payne Furnace Problem by John Wessels 10/7/02 08:54 AM (: 3, : 1)

Topic Follow-ups:

payne furnace problem by cgarcia1114 12/22/02 09:28 AM (: 2, : 0)
payne furnace problem by cgarcia1114 12/22/02 09:29 AM
Payne Furnance by Kathy 12/23/02 08:17 PM


	About \| FAQ \| Contact \| Sitemap \| Privacy Policy \| Terms of Use \| Help \| bobvilacontractors © BobVila.com 2008