bit

Posted by Fred McNulty on October 21st, 1997 05:53 PM
In reply to Get a better bit? by JT on October 20th, 1997 08:54 PM [Go to top of thread]

I use a new bit for every job I do.. I have used the ball bearing bits and the bits without the bearings. The results are the same.

Fred

Was this post helpful? Yes: or No:

Topic History:

Topic Follow-ups:

Use a lubricant by Herrick Kimball 10/21/97 09:18 PM
thanks by Fred McNulty 10/25/97 01:29 PM
Laminate Over Old Laminate by David Dunshee 11/3/97 06:35 AM
laminate over laminate by Herrick kimball 11/4/97 08:06 AM (: 12, : 2)
Painting existing plastic laminate cabinets by Leila 11/3/00 12:05 PM (: 1, : 1)
painting plastic laminate by Karen 10/21/02 04:03 PM (: 1, : 1)
Painting plastic laminate cabinets by Melissa 10/26/02 10:23 PM (: 2, : 1)
Painting Laminate Cabinets by Cindy 6/24/03 07:39 PM (: 3, : 2)
Painting Plastic Laminate Cabinents by D-Man 2/18/04 02:25 PM (: 6, : 0)
some info I found on painting laminate cabinets by Lisa 11/8/02 11:10 AM
NOOOOoooooo!!!!! by Ben 7/6/03 02:46 AM (: 4, : 1)
painting laminate cabinets by Jakob Andersen 12/3/03 01:05 PM
Desperately need a copy of Herrick Kimball's book by Allan 12/9/03 03:13 PM
Laminate over Laminate by David Dunshee 11/7/97 05:09 AM
painting over laminate kitchen cabinets by sue 4/4/98 09:50 AM (: 2, : 0)
Painting over Kitchen Laminate Cabinets by Carmen Rivera 3/14/04 08:29 PM
painting over laminate kitchen cabinets by Frank 7/2/04 11:11 AM
Burning cut material? by JT 10/22/97 07:03 PM
burn by Fred McNulty 10/25/97 01:24 PM
Sounds like you might be SCALPING your edges by Herrick Kimball 10/25/97 06:13 PM
scalping by Fred McNulty 10/25/97 06:51 PM
I've used every laminate trimmer on the market and... by Herrick Kimball 10/26/97 05:02 PM
trimming laminate countertops by bob 2/22/03 12:19 PM

BobVila.com