View ChannelsFeatured: Workshop
View ShowroomsFeatured: SprayFoamDirect.com - DIY Foam Insula...

BobVila.com

Home

Cutting with a circular saw...........

Posted by doug seibert on December 29th, 2002 09:14 AM
In reply to thanks Deeceefor the feedback by LJ in TX on December 29th, 2002 08:10 AM [Go to top of thread]

Post Reply |

Watch this Post

LJ.......Cutting with a circular saw cut from the back side so the "chipping" will occur on the backside...........If you are using a table saw cut with the face up so the blade cuts the face cleanly.....doug

Was this post helpful? Yes: or No:

Post Reply

Topic History:

any tips on cutting prepainte/or primed pegboard by LJ in TX 12/29/02 12:52 AM (: 1, : 0)
The fine tooth blade should do by deecee 12/29/02 02:35 AM
thanks Deeceefor the feedback by LJ in TX 12/29/02 08:10 AM

Topic Follow-ups:

thanks Doug another great tip by LJ in TX 12/29/02 09:30 AM
Masking tape by Moderator, Steve 12/29/02 10:17 AM
thanks Steve another great tip by LJ in TX 12/29/02 11:13 AM
Probably Too Late But... by Dodgeman 12/29/02 04:13 PM
primed pegboard cuts worked out fine by LJ inTx 12/29/02 08:52 PM