Purchased older Model 150 Craftsman drillpress.
Need help in locating manual/ parts# or just info.
1) Something is missing where base (w/front wheels) attaches to main vertial support. With bolt tightened all the way--base and pipe not secure-- what else should be bolt hole?
2) Idler/ pulley ratio wheel is not attached to anything. Does it mount to inside diameter of support tube as it enters up into the top pulley area... or should the support tube not extend so far up the top casting and the idler assembly secure to the inside diameter of the casting hole where the tube would be if allowed to come up that far??
The Webmaster has closed this topic to new posts. Please see the “Most Relevant Post” as suggested by the forum Moderator or go to top of topic for a full history of this topic as it may have been answered. We also recommend searching other topics to see if your question has been answered or starting a new topic.
