Rafter cuts

Posted by Steve K on June 14th, 1999 09:37 PM
In reply to rafters by dave whitener on June 14th, 1999 12:52 PM [Go to top of thread]

0 of 1 people found this post helpful

Post Reply |

Watch this Post

If you're talking about the plumb cut on either end, a framing square is without a doubt the quickest easiest way. A speed square is a good alternative and is preferred by some carpenters. Buy yourself a good square with the rafter tables.
Steve K.

Was this post helpful? Yes: or No:

Post Reply

Topic History:

rafters by dave whitener 6/14/99 12:52 PM

Topic Follow-ups:

rafters (roof) cuts by BJ Calmes 2/17/01 07:09 PM
roof rafters by lito perez 10/31/02 10:20 AM
Putting a gable roof over an existing concrete slab patio by Mike Wood 3/25/03 02:56 PM
angles by carolanndon@aol.com 3/21/04 05:53 PM
angles by carolanndon@aol.com 3/21/04 05:57 PM
Rafter cuts by Mark 3/4/01 02:09 PM
cutting rafter squares by Arthur Godfrey 10/20/03 11:51 AM
Using a framing square to determine the angle of cut for valley rafters. by doug gillum 12/10/01 05:29 PM
information by steven 12/16/02 07:01 PM
Using a framing square by Ray Snyder 1/4/03 01:27 PM
framing square by David J. Brandon 11/5/03 03:55 PM
Framing a sun deck. by Donald Jones 1/27/04 01:19 PM
framing roofs by patrick kearney 7/6/04 06:37 PM
Framing square link by Doug 7/6/04 07:08 PM
Stair Stringers by Todd Butzlaff 7/19/04 10:43 AM
using a framing for rafters by travis berger 12/13/03 06:40 PM
cutting rafters by jerry simpson 6/29/03 08:51 PM

BobVila.com

Rafter cuts