Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries
When undertaking a renovation project, an examination of the out-of-sight, out-of-mind spaces may be useful. If you’re thinking about converting an unfinished basement or attic area, this part of the inspection tour is especially important. In general, the least expensive way to add living space is by finishing unused areas—but to do so, those areas must be dry, adequately ventilated, and spacious enough to be usable. Even if you have no intention of converting any of your cellar or attic to living space, this step in the inspection process can still be valuable for the insights it can offer into the structure and working systems of your home.
When inspecting the cellar or attic, wear old clothes. A long-sleeved shirt and trousers are best, along with sneakers or work shoes. Basements and attics tend to be dirty and damp, and have awkward spaces that may require getting down on all fours. A couple of simple tools will be useful, too: a tape measure, a hammer, jackknife, maybe a screwdriver, definitely a flashlight. Grab your clipboard and you’re ready.
The Foundation. In areas where the ground freezes in winter, the foundation must reach below the frost line. That means the base of the house is buried below grade to a depth so that the freezing and thawing cycle won’t cause it to move. The cellar may be tall enough to stand up in (a full cellar); it may be a half-cellar called a crawl space; there may be no cellar at all if the place was built on a simple slab of concrete. In all cases, the principle remains the same.
When inspecting your cellar (if there is one), you’re looking for bad news first. Investigate the perimeter of the foundation. There are three categories of trouble common to basements: uneven settlement; dampness and decay, and insect infestation. You’re seeking signs of all three.
Uneven settlement means that certain portions of the foundation have settled more than others or that the action of the frozen ground has heaved some sections upward. Cracks in the wall are the classic sign of uneven settlement. When the walls are made of block, settlement cracking may resemble a staircase, climbing from one block to the next. Don’t panic if you find hairline cracking, but cracks of more than an eighth of an inch should be noted prominently on your list of issues to discuss later with your designer/contractor team.
What is the floor? If it’s just dirt, then water problems are likely, as the dampness can rise up every time there’s a heavy rain. Except in very arid climates, however, some basement dampness is normal. However, puddles or serious water stains on the wall can indicate the presence of too much water.
Keep an eye out for any signs of insect damage or structural decay in the wooden members, which occurs when wood is alternately dry and wet. You can test for decay using your screwdriver to probe for softness. In some unobtrusive location, jab the tool into the wood—the force required is more than a tap but less than a punch. If the driver penetrates the wood easily and deeply, serious rot is present. Make a note of it.
Insect damage is most likely in damp, dark environments. If in probing any wooden structural members you find channels in the wood (“galleries”), you probably have a termite or carpenter ant infestation. Note whether there are tiny pellets or gray residue (that’s insect excrement). Wood dust on top of foundation walls or on the floor far from any recent saw work can also indicate the presence of carpenter ants or powder-post beetles. If you see lots of tiny, round holes in wooden members, those are exit holes for beetles. Cobwebs with a dusting of what looks like sawdust is another sign. If the wood dust is a bright yellowish brown, it’s recent; if it’s gray, it’s been there a good while. Again, if you find insect signs, add that to your list of items requiring further investigation.
Typically cellars are crisscrossed with a network of pipes, wires, and perhaps ducts. While detailed evaluations of the working systems in the house are best left to the experts who will come later, take a commonsense look at the HVAC, electrical, and plumbing equipment. Is it a hodgepodge of new and old? Is the installation neat and orderly? Would you guess that each system was installed at one time or piecemeal, over many years, by a variety of installers and repairpeople of varying skills? If you detect leaks, rust, open electrical boxes, or any other signs of potential trouble, note them, too.
If you’re thinking of converting part of the basement to a playroom or other living space, you need to have adequate ceiling height, dry conditions, and safe access (cellar stairs that are steep, narrow, or that lack a proper railing are an accident just waiting to happen).
The Attic. There are three basic kinds of attics. In the unfinished attic, the walls and roof are open to reveal the structure. In the crawl attic, the structures are revealed, but there’s no place to stand meaning that, as with the crawl space foundation, you have to get down on all fours to move about. In the finished attic, the walls, floors, and ceilings are already finished and, therefore, “livable.”
Access varies greatly from one kind of attic to another. In many imposing Victorian houses, a full stairway leads up to a generously proportioned attic. With crawl attics, there’s often a ladder-stairway that pulls down from a hatch in the ceiling of an upstairs hallway. More than a few crawl attics have nothing more than a trap door that requires climbing a ladder to reach it.
Once you’re up there, you’re looking to assess the health of this portion of the house: Is the attic dry, well-ventilated, and structurally sound? Can you detect any signs of leaking? Look around the chimney for water stains on the masonry. How about on the insulation and along the length of the rafters? Are there water stains or fungus on the underside of the roof? Is there ventilation up there, such as windows, an attic fan, or louvers?
Are there streaks of creosote, a sticky brownish by-product of burning wood, on the chimney? Creosote is also flammable and means, at the very least, that the chimney needs to be cleaned. It may also mean that the flue liner isn’t doing its job.
Record what you’ve learned, and then get to work.