Repair antique sink
I have an antique porcelin sink in the bathroom that was attached to a marble stand. For some reason it came "unglued" How do I remove the old apoxy and what sh...
I have an antique porcelin sink in the bathroom that was attached to a marble stand. For some reason it came "unglued" How do I remove the old apoxy and what sh...
0
answersThere is concrete caulk for gaps up to 1/4" There is concrete crack filler for up to 1/2" The gap is now 1" in some places but less in other places. I can see whe...
1
answerspaint from my shutters have "chalked" on the brick front of mmy home. What's the best way to remove this chalking??Ron P
1
answerswhat do I use to seal an epoxy/stone finish over concrete patio?
1
answersI have a four year old house with a blacktop driveway that just barely fits two cars wide. We would like to widen it enough to be able to part next to eachother ...
1
answersWe are staining the exterior of our log home with High Sierra Log Stain. It has a glossy finish. We would also like to put a glossy stain on our deck but need s...
3
answersWould like some ideas on a lightweight ramp to enter my stationary houseboat and floatation suggestions since it is a 20 x 24 structure. more questions but have ...
0
answersI have a small imer minuteman mixer that can handle a batch output of 275 lbs. I am wanting to mix a 6 sack (4000 psi)recipe to pour some patio steps. Can anyo...
0
answersI have a list of home improvement projects, rewiring, replumbing, reroofing, painting the exterior of the house, adding a retaining wall. However, I don't know w...
1
answersI have 2 ***** Garage Door Openers, Model 139.53635SRT, 1/2 HP. I notice that the indicator light is flashing on one of these units. The flashing comes in a sequ...
0
answersHave a new ***** pushman mower, 7hp. The idle is set too fast for me and need to slow it down for an easier walking pace. ***** told me the speed was set that...
0
answersI need someone's opinions. We are looking at a house which has a raised foundation, built in 60's. Inspector found out there is a major horizontal crack on concre...
0
answersOn an old program, Bob went to a salvage place and was showing old porcelean baby tubs. I would appreciate hearing from anyone that remembers it or can tell me w...
0
answersI'm concidering purchasing a small sandblaster for on going wood / furniture old finish removal projects. I would appreciate any tips on this subject and what CFM...
1
answerscan anyone give me an idea how to remove the melted wax that has spilled in my cupboard
1
answersI am refinishing a 40 year old Buffet. I have stripped and sanded it down to a portion of the original finish (not bare wood). Do I need to apply a conditioner ...
0
answersI have a 3-year old fiberglass shower stall with a 1/2 inch chip near the drain. It doesn't appear to be leaking, but I would like to fix it before it gets worse....
1
answersI would like to use Extrudawood decking on my home, but my municipality is refusing because it is not BOCA approved. Is there any way around this requirement, or...
2
answersWe bought one of those ez-setup pools, the type with an air ring at the top and the rest is held up by water, but we don't have a spot in our entire yard that has...
0
answersMy land lord put astroturf on our fron tporch. It looks hideous. Right now I am scraping it off but all the glue ios stuck to the cement and is all rusted looki...
0
answers