I moved my mother's old Roll Top Desk. It's put together in 3 separate pieces - two pedestals of drawers and the desk top. We positioned the top as...
1
answers186
Views
I have owned a Craftsman 10" table saw for almost 15 years. The motor is rated at 1.5 HP (sold as 3 Hp peak) 120volts 13amps. The problem is recent...
5
answers16691
Views
I bought this back in the 80's when I refinished wood floors in my old Victorian home. I have hardly used it since. Now I can't remember, nor can...
2
answers1802
Views
My Depth Adjustment Ring is frozen & will not raise or lower the collet, etc. How can I unfreeze it? Thanks.
7
answers13990
Views
I have a wood paneled den that needs refinishing. It was probably last finished about 1960. The den consists of 3 paneled walls that have a judge's...
4
answers12610
Views
I am planning on building a deck (10' X 14') this summer and I want to slope it away from the house so that the water runs off away from the house ...
5
answers27945
Views
I have a YUBA SAWSMITH 700000 for sale, it is in ok/good condition. The wood table needs to be replaced; The saw runs, I have the locking key, belt...
0
answers84
Views
I recently power washed a retaining wall in our pool area, to bare wood. It looks great but I feel like it needs a seal to remain fresh looking. W...
0
answers72
Views
Need help in finding a Blade Guide holder for this saw. Any suggestions?
1
answers4120
Views
How to clean a metal roof before applying a coat of paint?? Oil or water base??
0
answers283
Views
My kitchen cabinets have a space built in for the refrigerator but the space isn't big enough for the type of fridge I want to buy. There is a smal...
3
answers10618
Views
I own a Craftsman 3/8" drill/driver which runs on a 9.6 volt battery pack. The drill is in perfect condition except the quick charger is dead. Th...
2
answers3216
Views
I have a model 113.278601C electronic radial arm saw that I love. The bevel system suddenly stopped working and won't move even when the 4 adjustme...
0
answers138
Views
I need a motor for a Craftsman thickness planer model 351.233731. Any help?
0
answers206
Views
Can I put new top boards over my old ones on my deck. It is 8’. I don’t have the money to replace the whole thing. It’s my front door entrance. It ...
0
answers210
Views
I have purchased (from the internet) a 12'long 3/8" thick granite countertop with a kohler stainless steel drop in sink. Do I need to add plywood ...
1
answers1111
Views
My Scheirich system is circa 1980 and uses triangular metallic glide assemblies with nylon rollers at the cabinet entry point. These rollers fit in...
2
answers4321
Views
I have a large shed with a loft. I added insulation and drywall to the lower portion, and installed a small AC/Heater to make it usable as a works...
0
answers206
Views
I recently moved to the West coast of Florida. In some architectural plans I see referencing to a 2 x 4 DEADWOOD. Does any one know what DEADWOOD i...
3
answers8507
Views
looking for a miter table for the above saw. The craftsman part No. is 976514-001
0
answers926
Views
