Metal Wall Studs
How do I attached wood trim to metal framing in walls? Do nail guns fasten to metal?
How do I attached wood trim to metal framing in walls? Do nail guns fasten to metal?
1
answersbought a house with T-111 siding. When I went to replace some that was bad, I found nothing under it exept insulation, vapor barrier and drywall. How bad is it t...
1
answersAloha,I got one third of a Pergo floor laid on a concrete slab living room floor before I realized that I needed to do a moisture test (a miscommunication: I was ...
9
answersAll of the corners in my house are rounded. The dry wall on the rounded corners is chipping off (mainly because the kids backpacks hit the corners). I have patc...
0
answersHow can I cut in walls that peak at 24 feet? There is an 18 wide inch plant shelf that runs 9 ft down one wall at about 8 feet high. It makes it difficult to get...
1
answersDoes anyone have the Super Deluxe model? Is it worth the extra money? Does it hold up well in the cold?
0
answersAnd another question. There is another porch that serves kinda as balcony. The previous tenants had put on the tar roofing, I guess not to damage the roof. Is the...
0
answersHi,I'm not sure how often this was done, but I have a 1920's home in Baltimore whose porch roof is itself a gutter. The wood on top of the rafters is angled to ma...
0
answersThat is my basic question. Is hardybacker on 1.5"x5" toungue in groove cardecking enough support for tile floor? It is dense fur and have had assurences from som...
2
answersI have the Amana Smoothtop Range (model #ACF4215AB) and I can't seem to find the answer to this question in any of the literature or the Amana website. Can I pla...
3
answersThe insulating blanket around my water heater has been sort of falling apart for some time now. I bought a new one, and this morning on impulse ripped the old one...
0
answersHello. I recently moved into a house that was built in 2000. The kitchen has hardwood floors. I recently noticed a slight dip in the floor, about 2 slats wide. ...
3
answersI'm having a 40 year old tar and gravel roof replaced with 3 tab shingles. For some reason the gravel is not scraping off. The roofer wants to replace all the b...
3
answersI have a wood frame sliding glass door that is about seven years old. We live in Ohio so winter is coming soon. The door has bowed slightly so that there is not...
0
answersElectrical Matters and Theory for Discussion! http://www.electricalmatters.com/forum/
0
answersI live in a mobile home (trailer). Our central heat/ac went out about a year ago. Installed window ac. Used several ceramic heaters last winter - 1 kerosene he...
1
answersIf I wrap the fitting going into the top of water heater, will that minimize the leakuntil I can have permanent repair done?It looks like it just started to leak.
2
answersI have a 10 yr old exterior front door that has the bottom seal breaking away. I have tried to find the manufacturer (called the original builder, looker all over...
0
answersI have a 2-family house (65 yrs old) heated by an oil furnace. 1st fl. apartment has no problem w/hot water. the 2nd fl gets hot water but it tapers off until it...
1
answersWe are in the process of remodeling our kitchen. We live in a "modular" home. There are two existing straight duct work lines thru the roof. Do we need to have...
4
answers