www.paintonce.com
Anyone know anything about this coating?
Anyone know anything about this coating?
0
answersPlease advise. I am not handy, nor do I have access to affordable help.I would like to purchase a duplex apartment (one side for me to live--the other side to re...
2
answersI have remodeled my basement and have left the brick suport columns visible to the finished room. They look great and add real style to the room. But, The expo...
2
answersI need to repair some cracks in stucco. I have some long cracks in stucco on corners about 3-4 feet long. How do I repair it and then paint it?
1
answersWe are building a new home that is a little unusual, the bedrooms are on the first floor while the kitchen and living room are upstairs. My problem is that my con...
2
answersI have a new home with 9ft Ceilings and with Dual Zone hot water/air gas boiler system. At what temperature should the air be coming out at it seems cool to warm?...
6
answersWe recently stippled over a plaster and lathe ceiling with joint compound. One ceiling came out beautifully, but the next one developed rust stains overnight. I...
2
answersHow do I paint dark pecan paneling?
2
answersWhat is the best way to "block" large DARK stains on my textured ceiling before I paint it? I have heard that if you use a stain blocker primer like Kilz that t...
4
answersI am looking to found information on Foam Ceiling Moulding. Can anybody help
0
answersWe are remodeling a bathroom. ALl drywall is down due to holes, patches etc. How do I make a nice, smooth 90 degree corner? I plan to paint only - this corner is ...
3
answersI live in a 1928 craftsman bungalow. Our upstairs consists of a landing, some closets, a spare bedroom, and attic crawlspace on either side of the living areas.I...
2
answersI recently purchased a Craftsman Table Saw with a cast iron top and drop-through leaves. (model # 315.22849) When i pulled the unit form the box, the cast top an...
4
answersI would like to remove the paint from my very old trim work. I wish to refinish the trim so the wood will show. I have seen ads for the peel away paint remover bu...
2
answersDoes anyone know of any kind of solution that weakens cement and concrete so it can be broken easier?
1
answersI'm hoping to install an island in our kitchen for some extra storage space and a breakfast counter. But available kitchen floor space is only 8x9 with a stove ju...
2
answersI need to replace some of my soffit and fascia boards. I'm thinking about using a synthetic or composite wood material that would resist rot. It seems like there ...
2
answersI am trying to find out some information on where two friends from Pelzer, South Carolina may be able to find funding to fix up their 100 year old plus cotton mil...
0
answersDoes anyone know, approximately, how much it costs to have a tankless water heater installed and how long the installation takes?
3
answersI need to replace some of my soffit and fascia boards. I'm thinking about using a synthetic or composite wood material that would resist rot. It seems like there ...
0
answers