how to clean soap scum off a shower door
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries
Does anyone know the size of the drive belt for a Noma Signature Series LXI-1540 lawn tractor from around 1992.
We have a 1946 Cape with an asphalt roof, master bdrm on first floor with second floor above. During heavy, driving rain only, we have a water lea...
Could anyone tell me where I might locate an owners manual for an old ***** Craftsman Belt Sander Model# 315-11720. I found the parts list and a d...
There is a concrete block pier in the crawlspace of a property we are wanting to purchase. It appears as if the concrete footing was poured imprope...
garage keypad not working - can not open door at all from outside I live in a small apartment complex and only have outside access to get into m...
I have an old Crafstman Band Saw, circa 1966. Model number is 113.24261. Of course all of the parts are no longer available and The lower guide a...
We live in three story duplex and for the past 3 summers we have had an foul smell linger in our second floor half bathroom (no shower/tub). Once t...
Hello everyone! I have some wrought iron patio chairs that have wicker backs that are all torn up. Does anyone know what kind of back I can instal...
I have a 1974 mobile home. I want to replace the 2 jalousie windows in the rear bedroom with a sliding glass door. How hard is this going to be? ...
I'm replacing a sliding patio door with a french door. Unfortunately the Rough Opening of the existing frame is a bit too narrow (the height is fi...
The ceiling hasn't been painted in 25 years . It's a little bit faded and is peeling in the middle. What is recommended
I began renovating my old Tudor house seven years ago and always used Benjamin Moore paint, inside and out. I love BM paint. It goes on beautifully...
We recently had a new architectural roof replaced and on the edge of our home , we have wooden overhangs similar to 1940's cottage, tongue in groov...
I desperately need some help. My Kenmore washing machine control panel was dented and I have the replacement part. I just have no idea how to go ...