balancing hot air heat system
i have a small tudor cottage with 4 finished floors. the furnace is located in the attic and the system is not zoned. my hvac contractor installed the system in t...
i have a small tudor cottage with 4 finished floors. the furnace is located in the attic and the system is not zoned. my hvac contractor installed the system in t...
0
answersI've been shopping for a replacement exterior door. I'm hearing conflicting reports with the durability of fiberglass vs. wood doors. I've been leaning toward f...
1
answersfirst off i'd like to thank u guys for replying so quickly. My hubby cuts the wood outside(weather permitting), we will try to get all of the wood up in one day ...
1
answersI Just bought a house built in 1978. I am putting in hardwood floors, and when I pulled up the carpet I found a crack going through three rooms. There is no gap i...
2
answersI'm trying to remove 3/4" hardwood planks to expose original wide-board heart pine beneath. I'd like to salvage the hardwood floor I'm removing for use in other r...
1
answersI have been asked by a condo owner to investigate peel and stick parquet wood floor for the bedrooms (concrete floors)-4th floor-3 yr old bldg. They are looking a...
1
answersHi, I am finishing off my basement and installed 20+ 6" cans in various rooms. Most rooms will be finished with "Ceiling Max" type of ceiling. For those of you ...
1
answersMy toilet bowl level drops a good inch every time my washer drains. This is a new problem (I think) in a seven year old home.The washer (2in.) line is tied in 4 ...
1
answersI have questions in two areas (for now--many to follow, I'm sure).Overall automation. Is there a "best" source for information about design and equipment. How/w...
4
answersI noticed a junction box in the basement that has 12 /2 armored cable coming out (opposite feed end) and 14 / 2 going in. I plan to add lighting fixtures on this ...
2
answersAbout 2 months after we moved into our newly-built home, we noticed cracks in the grout of our bathroom floor. Builder had his floorer come back, and they ended ...
4
answersWhat would be a good tool to cut plastic wall paneling. I have tried many different methods, and none are easy. I was just looking for some helpful advice.
2
answersMy husband and I recently purchased his grandfather's house. We want to refinish the random width pine floor in the master bedroom. It has at least two coats of...
1
answersI am looking to purchase a new furnace, and would like to know which one that folks out there think is the best (Carrier, Kenmore, Trane, Heil, etc...)If you can,...
0
answersTrying to buy a older home, built 1912. To keep this simple, the seller is essentially offering to install a Payne PG8MAA04-2090 furnace for us paying eseentiall...
1
answersMy husband and I recently moved into an old home. WE rent and were able to paint and clean a month prior to moving into the house. Something that has been a maj...
1
answersI'm having Home Depot put in new laminate flooring and they want $2.99 a foot to remove the tile plus extra to throw it away. Is this easy enough to do my self, I...
8
answersI need 2 Spinning Pole Flanges to fit a 2 inch pole and I have no idea where to go to look for them, does anyone have any suggestions. The final goal is to have ...
0
answersThese issues may be related. When running the natural gas fired furnace we get an odor that smells like burning electrical wire. The blower seems to work O.K.Wh...
3
answersOne year after moving into our newly-constructed home, we have drywall joints which are beginning to show up in the ceilings only. They feel smooth to the touch....
2
answers