User Profile - David, Moderator

Re: Vent Hood

First thing to do is remove grease and dirt. Scuff with very fine sandpaper. Spray a coat of primer and finish off with a finish color of your choice. hope it go...

1

answers

updated over 2 years ago by David, Moderator

Re: replacing cabinets

Some kitchen suppliers do provide the opportunity to purchase replacement doors. You will need the exact opening sizes and overlap details to get a price. Thank...

1

answers

updated over 4 years ago by David, Moderator

Re: Behr Paint Smells Like Pickles - Help

I like pickles but I certainly wouldn't want my house smelling like them. Here are a few things to try. Mix vanilla with water and place in room. Cut up a few ...

2

answers

updated almost 5 years ago by David, Moderator

Re: Cutting a 10-inch hole for a vent in cinder block

Hi, thanks for stopping by. Not sure what you're doing, but anyhow the easiest way is to use a hammer drill with a 1/2 inch masonry bit. Draw your circle on wal...

2

answers

updated almost 5 years ago by David, Moderator

Re: Kitchen Counter Top

If new granite is close in price, I would go with new granite. Recovering a existing countertop is a challenging situation. Thanks and good luck David

1

answers

updated almost 5 years ago by David, Moderator

Re: Need to replace recessed lights

You might be able to purchase new rims to replace the old ones

1

answers

updated almost 5 years ago by David, Moderator

Re: Transition piece from tile to carpet on steps

You could use a metal bull-nose to cap off tile on landing. Leave it go past a quarter inch or so. The carpet can then be tucked underneath. You can also buy ...

3

answers

updated almost 5 years ago by David, Moderator

Re: laying tile in sunroom w/ slant by doors

Hi there You don't say if you are using vinyl or ceramic tile. Also it is difficult without seeing. If using ceramic,you can cut the tile at the creases and a g...

1

answers

updated almost 5 years ago by David, Moderator

Re: paint not sticking to kitchen wall

Applying latex over oil usually doesn't work very well. Applying primer should solve the problem, not any primer will work. Go to your home improvement store an...

3

answers

updated almost 5 years ago by David, Moderator

Re: Floor Molding

Hi there Little tough to figure out without seeing, but here goes. Normally, door trim is usually a quarter inch or so thicker than base molding, If this is th...

1

answers

updated almost 5 years ago by David, Moderator

Re: Dishwasher placement

Hi there A dishwasher can be placed beside either. You would use a dishwasher end panel on the end next to the appliance. These are usually available in 3" and...

1

answers