The boiler has to be drained completly, and when job is complete the boiler needs to be refilled and all air will need to be removed.The air scoope...
1
answers1029
Views
Try TRUE VALUE,....I purchased a 10 footer for about 70.00 American. They may have a web sight. They are In Buffalo, NY all over the place. If yo...
2
answers737
Views
If it was cleaned within a month,.CALL EM BACK!!! It's warranty work. Make sure that it was taken apart and cleaned. Oil combustion has to be che...
2
answers712
Views
If it was cleaned within a month,.CALL EM BACK!!! It's warranty work. Make sure that it was taken apart and cleaned. Oil combustion has to be che...
2
answers621
Views
Cracks in the heat exchanger may be present, but the only way to tell is to call an oil certified technitian to look at the problem. A-couple of ...
2
answers662
Views
Heil is generally a good piece of equipment. All the Manufacturers offer a 5 year warranty on parts. Heil has come a long way from it's earlier d...
1
answers55
Views
Any heating supply house will have a B&G "Little Red" or "UpStart pump that will be perfect for this application. The only problem is that res...
1
answers806
Views
The only way you can check your blower motor is to put an amp meter on the common wire to see if anything is abnormal. Motor may be overheating,...
5
answers956
Views
If you have had problems in the past with not enough air, I would have to say it could possibly be the return. Since the 8" run you added will onl...
5
answers120
Views
James, Are you also having a problem posting a message? It comes back something like would you like to repost your message....or something like tha...
7
answers6
Views
James, Are you also having a problem posting a message? It comes back something like would you like to repost your message....or something like tha...
7
answers116
Views
James, Are you also having a problem posting a message? It comes back something like would you like to repost your message....or something like tha...
7
answers396
Views
OK Ya ready,....? Chances are that you have a line voltage t-stat controlling this heater. Inside every heater, especially electric baseboard the...
3
answers187
Views
Carrier, Lennox, York, Coleman...Basically ask the contractor or even better yet, look at some of his work. This will tell all as far as quality o...
2
answers1064
Views
A rough estimate of tonage needed is 5 ton. This is based on a 1840.0 sq' building with 12' cielings. This is fore the entire building. If cooli...
2
answers409
Views
A rough estimate of tonage needed is 5 ton. This is based on a 1840.0 sq' building with 12' cielings. This is fore the entire building. If cooli...
2
answers192
Views
Just a hint in setting up your hot water tanks. If using 2 tanks, the should be pipped in parallel meaning that both tanks should draw evenly when...
5
answers414
Views
All you have to do is continue to remove the air. All radiators must be air free. Sometimes this can take a-little while, but it has to be d...
6
answers405
Views
The pressure on the boiler should be about 10 to 15 lbs. 1 psi will raise the water in your boiler about 2.34 feet. 12 psi therefore will get you...
6
answers707
Views
The pressure on the boiler should be about 10 to 15 lbs. 1 psi will raise the water in your boiler about 2.34 feet. 12 psi therefore will get you...
6
answers140
Views
