Joining ABS & PVC in DWV system
Broward County code says yes that is ok, make sure you use purple primer before blue rain and shine glue
jrallenplumb
Member since 01/31/03Discussion History
How much for a basement bathroom?
You will still need to break the cement for the toilet or get a small step ladder to get on it. Take bids for the work, make sure you check license and insurance ...
1
answersupdated about 18 years ago by jrallenplumb
Brand New Hot Water Heater still not Working
Sounds like a pipeing problem to me. Check to see if any of your pipes are galvanized steel pipes, they may be in need of replacement.
19
answersupdated about 18 years ago by jrallenplumb
License for plumbing
well lets give it a go. To change a water heater anymore you need a permit in most areas as stated by the inspector. If the handyman is working under a Master Lic...
2
answersupdated about 18 years ago by jrallenplumb
Flushing problem
sounds like you have a toilet with bad jets (an integral part of the toilet), the jets are getting clogged up forceing you to flush twice to get water in the bowl...
4
answersupdated about 18 years ago by jrallenplumb
Redoing water pipes in house..copper?
How many baths, kitchens etc.
2
answersupdated about 18 years ago by jrallenplumb
Sewer Leak Location
video the line it is the best and gives a full look at the condition of the line from one end to the other.
1
answersupdated about 18 years ago by jrallenplumb
Slab Leak
oh yeah make sure your plumber gets a permit for this repair if it is required in your area. and always check for license and insurance before you deal with a sup...
2
answersupdated about 18 years ago by jrallenplumb
Sanipack macerating/pump
whether they are good or not is indeed 2nd to the fact if they are approved under the plumbing code for your area
1
answersupdated about 18 years ago by jrallenplumb
venting bathroom in basement
that 4 inch line is probably a waste line so dont cut it so fast. run water in your house and determine if it is indeed a vent line since they run vertical not ho...
1
answersupdated about 18 years ago by jrallenplumb
Slab Leak
Price is reasonable since I do them starting at $1900. but you do not want anything flexible. If he is running it overhead you should ask for copper, if the line ...
2
answersupdated about 18 years ago by jrallenplumb
Broken Tub Drain
thinking of the wall behind the tubs drain is it just drywall? Is it a adjoining closet wall? If the answer to either is yes would be just as easy to open the wal...
3
answersupdated about 18 years ago by jrallenplumb
Just Installed Pedestal Sink
Unfortunantly if you can't get your hands in behind the pedastal you will have to start over from step 1
1
answersupdated about 18 years ago by jrallenplumb
Bathroom vent question
Yes you can with a fernco (pliable connector) or other coupler, that stack is the existing vent.
1
answersupdated about 18 years ago by jrallenplumb
Why is my faucet backwards?
Is this a new shower mixing valve that was recently installed?
8
answersupdated about 18 years ago by jrallenplumb
mildew and clogged drain
Sounds to me like you may have a joint seperated in that main line and the snake will only make it worse. You'll need to open up the ceiling under the bathroom an...
2
answersupdated about 18 years ago by jrallenplumb
Shower won't stop running
turn the supply off to your house then pull the spindle behind the handle out and get a replacement from a plumbing supply company or a home improvemnet store lik...
1
answersupdated about 18 years ago by jrallenplumb
Hot water problems!!
First check too see if you have a supply leak. This is easy. Make sure all faucets are off and check to see if the spinner on your water meter is spinning. ( The ...
1
answersupdated about 18 years ago by jrallenplumb
can a hot water tank cause air or gas to create noise in pipes
actually its a marble in the hot water heater tube that starts bounceing when the hot water heater is turned on. call a plumber to remove them from the tubes
2
answersupdated about 18 years ago by jrallenplumb
Tub Noise when Toilet Flushes
PG, Hi, this is easy. Get a plunger and use it on the toilet for about 5 minutes. The line is partially blocked and not allowing the vent to work properly.
2
answersupdated about 18 years ago by jrallenplumb
