if it's sweated in. if it's threaded in (which i doubt) then yes.
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries
that pipe is deformed right where the o ring is supposed to make the seal,hence the leak. you might be able to save some money by opening the wa...
remove the overflow plate and stopper linkage(if any)and run the small snake through it with water in the tub.you'll know when it starts flowing.
remove the stopper,fill with cold water,then run a snake with a 1/4" cable down into the drain.flush with cold water when clear.
"I could probably figure this out with enough looking through my old text books," didn't the new unit come with directions? are there any oth...
that's what i thought you were refering to. usually if the trap or tailpiece is 1 1/4 and you need to convert up to 1 1/2 at some point you use ...
at least the ones i remember.if you can't find,just remove the toilet,then tear up the tile,remount the toilet don't caulk it down. then tile up t...
"I have low voltage wiring in the house anf have several wires loose and not attached to anytheing besides the box. How do I find out what they go ...
"IF a person didnt use the broiler, since it uses the same ignitor, couldnt one remove the ignitor from the broiler and put it in the oven position...
Hi Bob, i bought a used welder that requires a 50 amp circuit. what size wire do you recommend i use with a 50 amp double breaker?
that way you won't have to pay an electrican to tell you the problem's not in your house but in the outside line.
it sounds like to me that you have what is called a switch loop. the power enters at the fixture,then the hot is looped back through the switch. ...