vinyl siding as good as it may look would not be a very good choice for siding your portable car port...vinyl siding needs to have a solid backing ...
2
answers189
Views
start by cleaning w/ a mixture of water and murpheys oil soap...then allow to dry and wipe over the chairs w/ old english
1
answers838
Views
there is a product called naval jelly that you can use to clean the rust off of your saw...just rub it in using steel wool...it can be found at pre...
1
answers1005
Views
i would recommend leaving the wood siding on and just cover it up with 1/4" fanfold styrofoam insulation...it will give you a smooth surface to ins...
2
answers864
Views
I haven't had any experience w/ semco but I have had very good luck w/ the marvin tilt-pack replacement sash kits...replaced a few windows during a...
1
answers560
Views
You will need to use a laser level that can be mounted on a tripod. You make sure the laser in aimed on a level plane (some are self leveling othe...
2
answers1077
Views
you can probably buy them by the stick anywhere that rents nailers...however you will want to make sure you use ring shank nails for the deck board...
1
answers460
Views
If you are already willing to spend a little money to get the job done your best bet would probably be to buy an 18 guage brad nailer and shoot 1" ...
1
answers261
Views
check this out: http://forrest.woodmall.com/bladlasguid.html
1
answers1069
Views
you can also buy an abrasive blade for a circular saw...it gets kinda messy but it cuts like butter...plus it will work for pretty much any type of...
5
answers1042
Views
the only safe bet is that the stu spacing probably won't be consistant...did the stud sensor you were using have a deepscan mode on it...if not try...
2
answers798
Views
delta truck boxes makes them...they have a few different shapes and sizes
1
answers446
Views
just check around at stores where speed squares area sold...most places also sell the little guide book for a buck or two...its a good guide
3
answers742
Views
actually...stick nails are just another name for the nails framing nailers use (aka. stick nailers)...the differnce between clipped head and full r...
5
answers781
Views
the rotozip can be used to replace a jig saw to a certain extent...it works great for cutting drywall, tile, and any wood surface up to about 1/2-3...
3
answers828
Views
he's right...you need to replace your blade...if your doing trimwork i'd recommend a 60 or 80 tooth Freud Diable blade...its about the best you can...
2
answers917
Views
no there really aren't any permanent roof tar products that you can use to patch your roof...the best bet will be to replace the damaged shingle .....
5
answers1039
Views
tighty-packed would mean compressed more than what is necessary for it to stay in place (for unfaced insulation)...the more you compress insulation...
1
answers323
Views
to fix the hole just go to your local big box home improvement center and get a drywall patching kit and some joint compound...just follow the dire...
7
answers294
Views
that type of anchor is called a molly-bolt...there is also another anchor called an easy-anchor that you screw into the wall (no drilling) and then...
7
answers723
Views
