IMHO - Sickens is the worst thing that's ever happened to a can.
Get Help from Bob Vila
- Give-Aways & Offers
- Monthly Must Do's
- DIY Project Ideas
- Step-by-Step Guides
- Inspirational Photo Galleries
I assuming you didn't blow any holes thru your deck. As far as the fuzzies go, this is normal, go ahead and stain as you had planned, no sanding is...
With what you describe I would be more concerned with the water. Do you have well water? Does water coming out of other outlets have the same fil...
Craftsman vacs are notorious for having loud motors, and I'm afraid there isn't much you can do about it. Se-rs does sell a muffler for their vac'...
People don't ordinairly sand their decks. They just water blast then stain. Why do you want to sand? However, if your still inclined to do such ...
If you have a RAS or TS you'd be better off using them, don't think there's much in the way of collector value. I have a molding set from the 60's...
Yes, I have purchased a fair amount of items from HF. They have a pretty good customer service bunch there. Buying from HF is hit or miss deal, b...
To do such a thing where I live in Mich, a backflow valve would have to be installed per code. I think you'd want to do this anyways. Once you in...
what you seek does not exist. if you are extremely lucky enough to get a good match initially, chances are over time it will begin to show because...
I had a flex drive for about 18yrs, it worked fine the whole time, did everything I asked of it. I think the flex drive was better than a belt dri...
Yep, I know that, the topcoat isn't sticking to the primer. I think he is going back over the topcoat while it is semidrying, sometimes when you d...
Correct me if I'm wrong in understanding you. You are topcoating, but before the topcoat is completely dry you go over it again and that's when it...
Sounds like you're pretty well equipped, I too have a shop full of tools, and I love my RAS, I use it alot, the 2 tools I use the most are the TS a...
What's a brad nailer used for? Gee, quite abit, it's just not the right tool for what you want to do. I use brads sometimes when I make raised pa...
You really should go round head all the way. If you're ever in a position that your work needs to be inspected, alot of local codes around the nat...
Don't know what tool you're refering to but I used to have faith in products Bob Vila endorsed. But after trying his last few endorsements (screwo...
I agree, you can't go wrong with craftsman. They don't make the best stationary power tools, but their handtools are still among the best.