If it can be scraped down to a solid layer if you prime with anything it will still come off at the point of those layers that are peeling.I wouldn...
4
answers770
Views
orange peel should have very little texture,you may have what is called around here half knock,which is texture that is leveled at half height.If i...
3
answers332
Views
The trim if you are going to paint it anyhow,go buy some pine trim (Very Inexpensive to buy) at like m enards or h ome depot very cheap and will be...
1
answers491
Views
Thanks 5 thats exactly what I was trying to sa,but lately I have been working long hours and not much sleep trying to get all the projects done,see...
5
answers192
Views
My I ask why you wouldnt do all the trim all at once?I have never used any spray paint for trim or such so I couldn't tell you.But they do make a l...
5
answers768
Views
This sounds like a terrible job and the drywall paper may rip at the same time or you may accidently gouge the wall with a scraper or however you a...
3
answers755
Views
yes,well put just like that was what I was trying to say.The sealer part is after staining you might want to seal the wood which is like a varnish ...
5
answers1032
Views
It is pretty much impossible to do what you are trying to accomplish,this is a natural process that happens.You could put a coat of semi-gloss varn...
2
answers1043
Views
This is hard to do with a popcorn ceiling,I use an edger,or you need to push the tape a little ****er up with like a putty knife or even put the ta...
2
answers1067
Views
It shouldnt do this,I tighten mine on torq setting not speed setting,slower more torq will set it better.If yoyu a faster speed on the drill (no no...
5
answers204
Views
How accurate do you wanna be I own a painting business and cut my time by 60 % no more running tape point at the wall and shoot right?How high does...
3
answers930
Views
Well then Don you answered your own ques why would it matter it doesnt to you and you dont want the maint. on top of it.its not a big deal to you a...
3
answers245
Views
You can get many different colors of putty any place that sells paint.I dont know if I made this sound to confusing or if im tired from a long day ...
5
answers262
Views
reset the nails under the putty this will allow more room for your putty to match your color.Shouldnt be a problem you need just minimal room to ad...
5
answers807
Views
Try some kind of lube around where it slides on top and bottom.use heavily wipe excess,dura lube comes to mind works better than wd-40.
1
answers879
Views
I just got to add he has done this for about 8 years now and he made my wife and I a hutch in the 1st year and i tell you it is nice but still kind...
2
answers888
Views
Im not sure how big you are planning on doing,I like a plainer for rough boards runningit thru this then my table sander,pretty much eliminates alo...
2
answers1066
Views
How much snow you got on the ground?Reason I ask is if it is getting cold out your septic lines could be freezing up,causing just enough of a back...
2
answers649
Views
I was told once that most unheated basements run about 10-20 degrees cooler than the main house.You can easily heat basement with one of those I ca...
2
answers895
Views
I think if it is pealing that easy,no matter what you use.If the layers underneath do not have a good bond to what it is painted to you will have m...
4
answers383
Views
