carpenter bees
look a this Web site: http://www.menco.com/carpenterbee.htm?OVRAW=carpenter%20bees&OVKEY=carpenter%20bee&OVMTC=standard
look a this Web site: http://www.menco.com/carpenterbee.htm?OVRAW=carpenter%20bees&OVKEY=carpenter%20bee&OVMTC=standard
2
answersDo all light switches crackle, or just one particular one? You might want to focus on where the noise is coming from. Posssibly there's a loose wire on that sw...
2
answersNot enough info. Does it have some information on it somewhere, indicating its power requirements?
2
answersThat dimmer speed control switch is made to work with one unit attached. You can't guarantee it will work properly with two or more.
1
answersMake sure the safety sensors are clean, not dust-covered or poorly positioned. Also, make sure they're not in direct sunlight.
2
answersIt's probably the switch, not the chain. You can buy replacement switches at places that sell ceiling fans.
2
answersIf the opener works normally when operated by other openers and/or switches, then it probably means that your pushbutton on the transmitter in the car is stickin...
1
answersI and a coworker both recently bought Kenmore front loaders, based partly on the extremely high Consumer Reports rating for that model. We both are experiencing ...
8
answersAnybody have good or bad experience with spray-on siding? I'd like to learn if it's worthwhile.
2
answers...a little at a time, placing blocks higher and higher, under each corner until the desired height is reached.
2
answersNobody has replied - I think because there is no good answer. Lizards are about as common as flies where you live. I'm not trying to be funny when I say that I ...
6
answersMuch more info is needed. You didn't even say what the new gate is made of. Is it wood? What size pieces?
1
answersShower doors come in all kinds of shapes, sizes and styles. You haven't provided enough info for anyone to give an answer.
1
answersAnother important thing: disconnect the opener and them make sure that the door operates smoothly and with reasonable ease by hand. No binds.
3
answersGive the door itself a general tuneup. Tighten all screws and bolts, lube all hinges and rollers. Adjust the chain if needed, making sure it's not dragging or bi...
3
answersAny place that sells ceiling fans will have some ceiling-hugging versions. But be careful - if the fan is too close to the cieling, it won't move much air and wi...
1
answersI've heard that techs use a muratic acid solution to clean coils - don't know the strength.
1
answersThe holes in the wires won't hurt because it's low voltage.
3
answersOops, I forgot to mention that you should reduce the breaker size.
3
answers