Oops
I see that you said you had power on the white wire .... First ... nomally the black wire is hot so I ask ... You have power BETWEEN the white wire and what...
Discussion History
Maybe....
What you MIGHT have is ... One pair of wires (white and black) is from the breaker panel. The other pair goes to the switch. I expect you have a meter as y...
2
answersupdated over 15 years ago by tiddrma
belt
Check the drive belt on the motor. Might be slipping / broken / off.
7
answers
updated over 15 years ago by tiddrma
thanks
Thanks guys ... Will try when I get home. Seems draining is the favored opinion out there.
3
answersupdated over 15 years ago by tiddrma
Clear all the codes
When I bought my new house, first thing I did was to erase all the codes / remotes and reprogram ONLY the remotes I had. I remember there was a section in the man...
2
answersupdated over 15 years ago by tiddrma
Recharging air tank in shallow well pump system
Had some kids let the air out of the captive air tank on the sprinkler pump system. Was wondering the correct way to recharge the air. Do I need to turn off the p...
3
answershot??
does the fan feed hot?? MIGHT be the start capacitor. Check for it where the fan connects to the ceiling or where the light fixture attaches to the fan. The ne...
1
answersupdated over 16 years ago by tiddrma
Maybe ....
I expect the switch is not putting out real ac (uses a solid state switch ... SCR). Not a problem for a regular bulb, in fact it makes them last longer. For a lig...
1
answersupdated over 16 years ago by tiddrma
Rube Goldburg
Without getting involved with any electronics ... if the shed is dark inside save the 'heat' light, just use a light that comes on at night. You know, with a phot...
1
answersupdated over 16 years ago by tiddrma
Detail gun
If you're not painting a whole car ... Almost any detail gun . Your compressor is 2.4 cfm @ 90 psi. This badger model 400 is 3-5 cfm @ 30 psi and 'heavy'...
1
answersupdated almost 17 years ago by tiddrma
Just me ?
I have had pretty good luck with just a stud finder ... it only looks for changes in density.
2
answersupdated almost 17 years ago by tiddrma
OOPS
I read your message again and sounds like mobile home or wood subfloor ?? I jumped the gun there, sorry. The concrete is more for a cement floor ( not impossib...
3
answersupdated almost 17 years ago by tiddrma
Big room ??
Self leveling concrete ... About $30 for 50 pounds. Expensive for a big room but sometimes you have to spend to save work. After you mix it, it looks like wate...
3
answersupdated almost 17 years ago by tiddrma
three way switch
Sounds like you got a three way ( off Dim Bright ) switch. Nomally black is power in, blue is to the light.... The third wire would go to the extra fillament in t...
1
answersupdated almost 17 years ago by tiddrma
Maybe try here ..
http://www.brayden.com/techsupport.html
2
answersupdated almost 17 years ago by tiddrma
End cap ?
I assume the cabinet comes up through the counter (taller than ). They make end caps (for where the end of the counter meets the wall ) The cap is wood inside ...
1
answersupdated almost 17 years ago by tiddrma
maybe ...
Is the light controlled with a pull string switch or a wall switch ?? If it has a wall switch then the unswitched power is probably there and will need to be pull...
1
answersupdated almost 17 years ago by tiddrma
Height
One more thing ... The normal mounting height should be no more than 32 inches from the bottom of the microwave to the top of the stove and no LESS than 24 in...
5
answersupdated almost 17 years ago by tiddrma
adapter
They do have an adapter ... you can get them at the big home stores for a few dollars. They are about 10 inches tall so you will need at least that much from the ...
5
answersupdated almost 17 years ago by tiddrma
How old ??
How old is the house / wiring ?? Is the age of the house or remodel correct for a gfi outlet ?? I will confirm the odd placement for gfi's. I lost all elect...
3
answersupdated almost 17 years ago by tiddrma
