miter saw blades
It's looking like I need a good 80 toother with a thin kerf. thanks,
Discussion History
Miter Saw Blade Question
What would be the best 10" blade to use on my Craftsman compound miter saw for cutting crown, window and door moldings. I've used the 40t carbide blade that ca...
2
answersupdated over 15 years ago by Tom Smeal
Floor tile followup
Good point Timbear. I did this for an upstairs bathroom that had a sheet vinyl floor. I used cement backer board screwed directly through the vinyl floor into the...
1
answersupdated over 15 years ago by Tom Smeal
Decorative molding installation question
We are contemplating installing crown and window moldings inside our 1965 built colonial style home. But there are metal strips installed on all the drywall wall ...
2
answersupdated over 15 years ago by Altereagle
Floor tile question
We wish to put a ceramic tile floor in the kitchen of our 1965-built wood frame home. The wood based floor has an Armstrong Solarium waxless vinyl floor cement...
1
answersupdated over 15 years ago by Tom Smeal
Wall Tile Over Paint
I intend to place one row of 4" X 4" decorative tiles as a band arounf three walls in the bathroom. It's the dry area of the bathroom. Is it OK to stick (AcrylPro...
1
answersupdated over 16 years ago by homebild
felt under tile
The roofing felt idea came from a tile book I bought. It was suggested, along with the Red Guard option you mentioned. Thanks for the advice. tom
5
answersupdated over 16 years ago by Tom Smeal
Waterproofing membrane
I just installed 1/2" wonderboard over our 5'X 5' bathroom floor (excluding bath/shower). Is it advisable to install 15lb roofing paper on top of the wonderboard ...
5
answersupdated over 5 years ago by BV007349
Thanks
Thanks for the advice, that's what I hoped someone who knows would suggest.
2
answersupdated over 16 years ago by Tom Smeal
Wonderboard floor joints not flat
I just installed four pieces of 1/2" wonderboard on top of my sheet vinyl (not cushioned) bathroom floor. I used Flexbond thinset. Try as I might, I could not get...
2
answersupdated over 16 years ago by Tom Smeal
New Power Panel needed
I have an old (1965) Federal Pacific Stab-Lok type,100Amp power panel in my house. I have 11 circuit breakers, a mix of 15A and 20A. The house wiring is all #12 s...
1
answersupdated over 16 years ago by Tom O
New Floor Height question
Thanks Floorcraft.By the way, I'm going to use cement backerboard for a wall that will only be partially tiled. Am I right to assume I can prime and paint this ba...
3
answersupdated over 16 years ago by Tom Smeal
New Floor Height question
I'm installing a ceramic tile floor in my second floor bathroom. The existing floor is 40 year old sheet vinyl, smooth and solid and fairly level. My question is ...
3
answersupdated over 16 years ago by Floorcraft
