Not as good as I thought!
I had posted a message about my great sweating skills and then two weeks later one of my joints started to leak. I took the joint apart and tried it again. This...
I had posted a message about my great sweating skills and then two weeks later one of my joints started to leak. I took the joint apart and tried it again. This...
1
answersThanks for the replies to my question. I purchased a bottle of MAPP fuel; the difference is night and day. I was able to install two shut-off valves and replace...
4
answersWhat is the best method to repair thin cracks in the basement floor? Should this even be a concern.
1
answersI need to run copper line for my basement bath. To do this, I want to add shut-off valves in the unfinished part of the basement so that I can take my time plumb...
4
answersIt's been a long time since I've worked with this. But, make sure you are using the saw the same way everytime (if using a hand saw). Also, pay attention to how ...
2
answersI can't answer your first two questions, but the last question is yes. 14g 15amp circuit will support about 1800 watts and code says to stay 80% or below the tot...
1
answersThanks for the posts. I tapped into the light nearest my recessed lighting to obtain power. The black wire is the switch leg and the red powered the lights. Al...
3
answersI purchased a Remington 22 cal. (Ramset also makes several kinds) nail gun for $15.99 at Home Depot. The one I purchased requires that you load the gun with one ...
4
answersMy circuit runs seven light fixtures. 14/2 runs from the box to the first light - then three wire to the remaining lights - then two wire to the switch. I'm try...
3
answersGetting ready to frame a basement and trying to decide between metal vs wood. Saw a metal stud wall this weekend and it seems very weak. What are the pros and c...
3
answersI'm adding outlets in a basement to a 15amp circuit on 14g wire. The circuit will basically support a frig and an entertainment center. How many outlets are all...
4
answers