Latest Discussions : Tools & Workshop

westc

12:20PM | 01/23/03
Member Since: 12/14/02
10 lifetime posts
I am working on an older house that has 7.5 inch yellow pine baseboard with a roundover on the top edge. Is there anywhere I can get this pre made or am I goung to have to find someone to mill it for me?

Altereagle

08:00PM | 01/23/03
Member Since: 12/27/02
543 lifetime posts
Clear finish? That why you need to go back with pine?

You'd be better off to simply router the roundover, dependent on the amount of run. That said if you aren't into a clear finish but are going to paint rip 3/4 MDF and router that.

In any event you'll pay for the additional board ft. as most suppliers sell the stock that way, so better you have it have them right? To bad you can't take some of the 7 1/2 from one room and use it in another (if it's a claer finish) then go back and place the 7 1/4 in that room... cheaper stock wise, but not labor wise.

joed

04:28AM | 01/24/03
Member Since: 09/17/02
524 lifetime posts
You could glue up some 1/4 round onto flat pine. Or skip the the glue and nail it together.


Post a reply as Anonymous

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply choose button

Anonymous

Post new button or Login button
Register